2007 Fraste FS250 Drill Rig for Sale – #B221019A

//Add to cart

Request More Information and Pricing

Product Description

 

Rig Specifications:

  • Make: Fraste
  • Model: FS250
  • Year: 2007
  • Hours: 3,450
  • Engine: Tier 3 John Deere 6.8L, 250 HP
  • Pull back @ 26,400lbs
  • Crowd @ 17,600lbs
  • Casing Jacks rated at 20 Ton
  • The break out clamps are rated for 60-300mm OD sized pipe
  • Single Winch @ 3600Kg
  • 800mm head cross slide movement
  • High Speed – 190 RPM, Low Speed – 95 RPM 

 

As it has been rebuilt, pretty much every pin/bushing has been replaced, it’s as tight as new. If the piece was removeable, its been taken off for sandblast and paint. The closed loop hyd. pump has been rebuilt. The drill head has been fully rebuilt, brand new hydraulic motors, pinion gears, bearings. The jaws in the rod chuck and rod chuck housing are new. Many hydraulic cylinders have been rebuilt, rods polished. I have added modifications where the design fell a little short. A great example is the original drill could crush the engine shroud if the mast was towered down in the wrong position. Now it is “driller proof” as I like to say and can no longer be damaged. The track chains has been replaced. The leaf chains and bearings for the idlers are new. Full cleanout of the hydraulic tank and new oil filters installed. Included spares are a few joysticks, shims, seals, bushings etc. 

The drill currently has a bolt on sub for NWJ thread. The rod handler and chuck are set up to the same diameter, which is 2.875″/73mm outside diameter rod. The rod handler will work with 10′ / 15′ and I believe max would be 18′ long rods. The weight is 53,000lbs, I think that is with a full load of drill pipe in the rod rack. It was last used on a production job in 2012. . 

The rotary head I have has 2 brand new Danfoss OMT Hydraulic drive motors (not rebuilt but in fact zero time motors), new pinion gears, refinished plasma sprayed hard surfacing at both rotary seal locations, new bearings and seals throughout, new swivel seals, brand new rod chuck inserts and housing (latest revision from Fraste which has a bolted nose rather then threaded on).  All hydraulic cylinders for the rod handler have been rebuilt.  All parts sandblasted and painted with Endura.  

The Gardner Denver mud pump is a 5×6. Rated capacity of 570L/min @ 20 Bar. There is a small foam injection pump which flows 34 L/min @ 50 bar

Hydraulic Pumps:

  • (2) open loop at 200L/min each. 280bar
  • (1) closed loop at 150 L/min at 280 bar

 

There is the unused PTO pad on the engine for which further hydraulics may be added

 

Asking Price: $250,000

For more information on this drill rig, please contact the Rig Source Sales Team at (630) 365-1649

This unit is available by a Third Party, view full disclaimer here.

 

 

 

Reviews

There are no reviews yet, would you like to submit yours?

Be the first to review “2007 Fraste FS250 Drill Rig for Sale - #B221019A”